holden.wiki

• MODEL SELECTION INDEX
• MY 2003 VY & V2 II SERIES - SERVICE INFORMATION
• SECTION 12P - WIRING DIAGRAMS
  • 1. GENERAL INFORMATION
  • 2. ELECTRICAL CIRCUIT DIAGNOSIS
    • PROBLEM EXAMPLE
  • 3. TEST PROCEDURES
    • 3.1 ELECTRICAL FAULT DIAGNOSIS
      • POSSIBLE ELECTRICAL MALFUNCTIONS
      • CIRCUIT FAULTS
      • OPEN
      • SHORT TO EARTH
      • SHORT TO VOLTAGE
      • HIGH RESISTANCE PROBLEMS
    • 3.2 TROUBLESHOOTING TEST EQUIPMENT
      • JUMPER WIRE
      • TEST LIGHT
      • SELF-POWERED TEST LIGHT
      • MULTIMETERS
    • 3.3 DIGITAL MULTIMETER
      • USE OF A MULTIMETER
      • SELECTION OF MULTIMETERS
      • VOLTAGE MEASUREMENT
      • RESISTANCE MEASUREMENT
      • CONTINUITY TESTING
      • DIODE TESTING
      • CURRENT MEASUREMENT
  • 4. DIAGNOSTIC TESTS
    • 4.1 TESTING FOR VOLTAGE
    • 4.2 TESTING FOR CONTINUITY
    • 4.3 TESTING FOR VOLTAGE DROP
    • 4.4 TESTING FOR SHORT TO EARTH
      • USING A TEST LIGHT OR VOLTMETER
      • USING A SELF-POWERED TEST LIGHT OR OHMMETER
      • USING A SHORT FINDER
      • USING A COMPASS
      • USING A CIRCUIT BREAKER
    • 4.5 OPERATING A SHORT FINDER
    • 4.6 MEASURING CURRENT
    • 4.7 DETECTING INTERMITTENT ELECTRICAL FAULTS
      • DIAGNOSTIC PROCEDURE
      • CHECKING TERMINAL CONTACT
      • METER CONNECTIONS
  • 5. WIRING REPAIR PROCEDURES
    • 5.1 GENERAL INFORMATION
    • 5.2 PERFORMING WIRING HARNESS REPAIRS
      • SOLDERING
      • THE FIVE POINTS TO SOLDERING
      • JOINING WIRE
    • 5.3 SPLICING WIRING USING SPLICE CLIPS
    • 5.4 ABS AND SRS WIRING REPAIR
      • ABS AND SRS WIRE PIGTAIL REPAIR
      • WIRING REPAIR
      • ABS AND SRS WIRING SPLICE REPAIR
    • 5.5 SPLICING TWISTED OR SHIELDED CABLE
    • 5.6 SPLICING IN-LINE HARNESS DIODES
    • 5.7 HEATED OXYGEN SENSOR (HO2S) WIRING REPAIRS
    • 5.8 TERMINAL REMOVAL
      • REPAIRING PUSH-TO-SEAT AND PULL-TO-SEAT CONNECTORS
      • WEATHER PACK ® CONNECTORS
  • 6. READING 12P WIRING DIAGRAMS
    • GENERAL
    • SHEET IDENTIFICATION
    • WIRE IDENTIFICATION
    • GRID REFERENCE
    • CONTINUATION REFERENCE
    • ASSEMBLY IDENTIFICATION
    • ASSEMBLY CONTINUATION
    • ASSEMBLY CONNECTOR IDENTIFICATION
    • ASSEMBLY CIRCUIT IDENTIFICATION
    • INFORMATION WITHIN AN ASSEMBLY
    • HARNESS SPLICES
    • GROUND LOCATIONS
    • CIRCUIT SYMBOLS
  • 7. CONNECTOR LOCATION ILLUSTRATIONS
  • 8. FUSE AND RELAY PANEL LOCATIONS
  • 9. IVED ELECTRICAL SCHEMATICS
    • COMPONENT LOCATION CHART
      • ELECTRICALLY OPERATED MECHANICAL DEVICES
      • INDICATORS, ALARMS & SIGNAL DEVICES
      • INDUCTORS
      • MEASUREMENT, DISPLAY & TEST DEVICES
      • MODULES, SYSTEMS AND SUB-ASSEMBLIES
      • MOTORS
      • OTHER DEVICES & EQUIPMENT
      • POWER SUPPLIES
      • REGULATORS & AMPLIFIERS
      • RESISTORS
      • SEMI CONDUCTORS
      • SWITCHES
      • TRANSDUCERS
      • TRANSMISSION PATHS, CONDUCTORS & ANTENNAS
  • 10. SPECIAL TOOLS